Arikah Map

Tunnel

Tunnel:A disused railway tunnel now converted to pedestrian and bicycle use, near Houyet, Belgium
Enlarge
A disused railway tunnel now converted to pedestrian and bicycle use, near Houyet, Belgium

A tunnel is an underground passage. The definition of what constitutes a tunnel is not universally agreed upon. However, in general tunnels have a ratio of the length of the passage to the width of at least 2 to 1. In addition, they should be completely enclosed on all sides, save the openings for the length of the covered area.

A tunnel may be for pedestrians or cyclists, for general road traffic, for motor vehicles only, for rail traffic, or for a canal. Some are aqueducts, constructed purely for carrying water — for consumption, for hydroelectric purposes or as sewers — while others carry other services such as telecommunications cables. There are even tunnels designed as wildlife crossings for European badgers and other endangered species. Some secret tunnels have also been made as a method of entrance or escape from an area, such as the Cu Chi Tunnels.

In the United Kingdom a pedestrian tunnel or other underpass beneath a road is called a subway. This term was also used in the past in the United States, but is now used to refer to underground rapid transit systems.

The longest canal tunnel is the Standedge Tunnel in the United Kingdom, which stretches over three miles.

Tunnel:Colorful pedestrian Light Tunnel connecting two terminals in Detroit's DTW airport.
Enlarge
Colorful pedestrian Light Tunnel connecting two terminals in Detroit's DTW airport.
Tunnel:The North East MRT Line in Singapore is a fully-underground rail line.
Enlarge
The North East MRT Line in Singapore is a fully-underground rail line.

The central part of a rapid transit network is usually built in tunnels. To allow non-level crossings, some lines are in deeper tunnels than others. At metro stations there are usually also pedestrian tunnels from one platform to another. Often, ground-level railway stations also have one or more pedestrian tunnels under the railway to enable passengers to reach the platforms without having to walk across the tracks. However, in the United Kingdom bridges are an equally popular method of pedestrian access between two or more different railway station platforms.


Contents

Construction

Tunnel:A tunnel boring machine that was used at Yucca Mountain, Nevada
Enlarge
A tunnel boring machine that was used at Yucca Mountain, Nevada
Tunnel:Gotthard Base Tunnel under construction
Enlarge
Gotthard Base Tunnel under construction

Tunnels are dug in various types of materials, from soft clays to hard rocks, and the method of excavation heavily depends on the ground conditions.

Cut-and-cover

Cut-and-cover is a simple method of construction for shallow tunnels where a trench is excavated and roofed over. Strong supporting beams are necessary to avoid the danger of the tunnel collapsing.

Shallow tunnels are often of the cut-and-cover type (if under water of the immersed-tube type), while deep tunnels are excavated, often using a tunnelling shield. For intermediate levels, both methods are possible.

Boring machine

Tunnel-boring machines (TBMs) can be used to automate the entire tunneling process. There are a variety of TBMs that can operate in a variety of conditions. One type of TBM, called an earth-pressure balance machine, can be used deep below the water table. This pressurizes the cutter head with air or another fluid in order to balance the water pressure. As a result operators of the TBM must go through decompression chambers, much like divers.
The biggest TBM built was used to bore the Green Heart Tunnel (Dutch: Tunnel Groene Hart) as part of the HSL-Zuid in the Netherlands. Its diameter is 14.85 m. [1]

NATM

The New Austrian Tunneling Method (NATM) was developed in the 1960s. The main idea of this method is to use the geological stress of the surrounding rock mass to stabilize the tunnel itself. Based on geotechnical measurements, an optimal cross section is computed. The excavation is immediately protected by thin shotcrete, just behind the excavation. This creates a natural load-bearing ring, which minimizes the rock's deformation.

By special monitoring the NATM method is very flexible, even at surprising changes of the geomechanical rock consistency during the tunneling work. The measured rock properties lead to appropriate tools for tunnel strengthening. In the last decades also soft ground excavations up to 10 km became usual.

Underwater tunnels

There are also several approaches to underwater tunnels, for instance an immersed tube as in Sydney Harbour.

Other

Other tunneling methods are:

Choice of tunnels vs. bridges

For water crossings, a tunnel is generally more costly to construct than a bridge. However, navigational considerations may limit the use of high bridges or drawbridge spans when intersecting with shipping channels at some locations, necessitating use of a tunnel. Additionally, bridges usually require a larger footprint on each shore than tunnels; in areas with particularly expensive real estate, such as Manhattan and urban Hong Kong, this is a strong factor in tunnels' favor. Boston's Big Dig project replaced elevated roadways with a tunnel system in order to increase traffic capacity, hide traffic, reclaim land, redecoration, and reunite the city with the waterfront. Examples of water-crossing tunnels built instead of bridges include the Holland Tunnel and Lincoln Tunnel between New Jersey and Manhattan in New York City, and the Elizabeth River tunnels between Norfolk and Portsmouth, Virginia and the Westerscheldetunnel, Zeeland, Netherlands. Other reasons for choosing a tunnel instead of a bridge are aesthetic reasons (i.e. preserve the above-ground view, landscape, and scenery), and also for weight capacity reasons (it may be more feasible to build a tunnel than a sufficiently strong bridge).

Some water crossings are a mixture of bridges and tunnels, such as the Denmark to Sweden link and the Chesapeake Bay Bridge-Tunnel in the eastern United States.

Very short tunnels

A short tunnel can be a convenient way to build an overbridge. Very short tunnels resemble overbridges. One example of a short tunnel is the Croom Tunnel on the Nowra, New South Wales railway line.

Artificial Tunnels

Overbridges can sometimes be built by covering a road or river or railway with brick or still arches, and then levelling the surface with earth. In railway parlance, a surface-level track which has been built or covered over is normally called a covered way.

Snowsheds are a kind of artificial tunnel built to protect a railway from avalanches of snow. Similarly the Stanwell Park, New South Wales steel tunnel, on the Nowra, New South Wales railway line, which protects the line from rockfalls.

Common utility ducts are man-made tunnels created to carry two or more utility lines underground. Through colocation of different utilities in one tunnel, governments and companies are able to reduce the costs of building and maintining the utilities.

Examples of tunnels

In history

Tunnel:Interior of the Thames Tunnel, London, mid 19th century
Enlarge
Interior of the Thames Tunnel, London, mid 19th century

See also the History of Rapid transit.

The longest

Notable

Other uses

Excavation techniques, as well as the construction of underground bunkers and other habitable areas, are often associated with military use during armed conflict, or civilian responses to threat of attack.

Media

  • Fenghuoshan tunnel (file info)

    </li>

  • Problems seeing the videos? See media help.</li></ul></div>

    Natural tunnel

    See also

    Categories


    Tunnels | Bridges

  • Find

    Find

    Find